Working With Sections (Axis Only); Spreading With Reduced Sections - Rauch QUANTRON-A AXIS-M 20 Q Instruction Manual

5 Spreading operation with the QUANTRON-A control unit
5.2

Working with sections (AXIS only)

5.2.1

Spreading with reduced sections

Spreading can be realized with sections on one or both sides to adapt the full
spreading width to the field requirements. Each spreading side can be adjusted
in 4 (VariSpread Dynamic) or 2 (VariSpread 4) steps.
See

Press the L%/R% key until the desired function keys are displayed.

4
Figure 5.1:
[1] Right section will spread to the entire half
[2] Function keys for increasing or reducing the spreading width on the right
[3] Function keys for increasing or reducing the spreading width on the left
[4] Left section is reduced to 2 steps
Each section can be gradually reduced or increased in 2 and/or 4 steps.
1. Press the Reduce left spreading width function key or the Reduce right
spreading width function key.
 The section of the spreading side will be reduced by one step.
2. Press the Increase left spreading width or the Increase right spreading
width function key.
 The spreading side section will be increased by one step.
88
2.1: Overview of supported versions, page
3
Operating screen for spreading operation with sections
5.
2
NOTICE
1