Spreading Operation With The Quantron-A Control Unit; Telimat - Rauch QUANTRON-A AXIS-M 20 Q Instruction Manual

5

Spreading operation with the QUANTRON-A control unit

The control unit QUANTRON-A supports you in setting up your machine before
you start your work. During spreading, control unit functions are also active in the
background. The quality of the fertiliser spreading can be monitored using these.
5.1

TELIMAT

The TELIMAT option is pre-configured for the control unit at the factory!
TELIMAT with hydraulic remote control
The TELIMAT is hydraulically moved to its working or idle position. The TELIMAT
can be activated or deactivated by pressing the T key. Depending on the position,
the display shows or hides the TELIMAT icon.
TELIMAT with hydraulic remote control and TELIMAT sensors
If TELIMAT sensors are connected and activated, the TELIMAT icon is shown
on the display of the control unit as soon as the TELIMAT has been hydraulically
brought to the operating position. If the TELIMAT is moved back to the idle posi-
tion, the TELIMAT icon is hidden. The sensors monitor the TELIMAT adjustment
and activate or deactivate the TELIMAT automatically. The T key has no function
for this option.
If the status of the TELIMAT unit cannot be detected for more than 5 seconds,
alarm message 14 will be displayed. Refer to chapter
ings, page
Spreading operation with the QUANTRON-A control unit
n CAUTION
Risk of injury due to the automatic TELIMAT adjustment!
By pressing the T key, the unit automatically moves to the bound-
ary spreading position by means of an electrical actuating cylinder.
This may cause injury and material damage.
 Before pressing the T key, make sure that no one is in the
machine's hazard zone.
99.
NOTICE
6.1: Alarm message mean-
5
87