Alarm Messages And Possible Causes; Alarm Message Meanings - Rauch QUANTRON-A AXIS-M 20 Q Instruction Manual

6

Alarm messages and possible causes

Various alarm messages can be displayed on the control unit display.
6.1

Alarm message meanings

No. Message on display
1
2
3
4
5
7
8
9
10
11
Fault in dosing system. Stop! The metering system actuator cannot reach
Maximum outlet reached!
Speed or application rate too
high
Flow factor is outside limits.
Hopper left empty.
Hopper right empty.
Data will be deleted!
Delete = START
Cancel = ESC
Min. quantity (150 kg) not
achieved, old factor valid.
Application rate
Min. setting = 10
Max. setting = 3000
Working width
Min. setting = 2.00
Max. setting = 50.00
Flow factor
Min. setting = 0.40
Max. setting = 1.90
Alarm messages and possible causes
Meaning
Possible cause

the target value.
Blockage

No position feedback

Metering slider alarm
The maximum metering opening is

reached.
The set application rate (+/- quantity) ex-

ceeds the maximum metering opening.
The flow factor must lie within a range of
0.40 - 1.90.
The newly calculated or entered flow

factor is outside the range.
The left level sensor reports "empty".
The left hopper is empty.

The right level sensor reports "empty".
The right hopper is empty.

Safety alarm to prevent the unintentional
deletion of data.
Flow factor calculation not possible.
The application rate is too low to calcu-

late the new flow factor when the re-
maining quantity is weighed.
The old flow factor is retained.

Reference to the value range of the Appli-
cation rate
Entered value is not permitted.

Reference to the value range of the Work-
ing width.
Entered value is not permitted.

Reference to the value range of the flow
factor.
Entered value is not permitted.

6
99