Scanning Takes A Long Time - Fujitsu fi-7300NX Operator's Manual

Scanning Takes a Long Time

Check the following points
● Does the computer meet the recommended requirements? (page 192)
● If a USB connection is used, is the USB cable connected to the USB 1.1 port on the computer? (page
192)
Did you start a scan while the computer was unstable (for example, immediately after computer start-up
●
or logon)? (page 192)
Are the rollers clean? (page 192)
●
If the problem persists, check the items in
first, then contact the distributor/dealer where you purchased this product. Or, make an inquiry by
referring to the contact information at the Contact for Inquiries section in Safety Precautions bundled with
this product.
●
Does the computer meet the recommended requirements?
Solution
Use a computer that meets the recommended CPU, memory, and other requirements.
For details, refer to
●
If a USB connection is used, is the USB cable connected to the USB 1.1 port on the computer?
Solution
If a USB connection is used, connect the USB cable to the USB 3.1 Gen1/USB 3.0/USB 2.0 port.
●
Did you start a scan while the computer was unstable (for example, immediately after computer start-up
or logon)?
Solution
When you start or log onto the computer, wait a while before starting a scan.
●
Are the rollers clean?
Solution
Clean the rollers.
For details, refer to
Before You Contact the Scanner Service Provider (page 213)
System Requirements (page
Cleaning the Inside of the Scanner (ADF) with a Cloth (page
192
52).
Troubleshooting
119).