Scanner Maintenance And Inspection Cycle [Maintenance And Inspection Cycle] - Fujitsu FI-7600 Operator's Manual

Chapter 8 Operational Settings
Scanner Maintenance and Inspection Cycle
[Maintenance and Inspection Cycle]
Specify the period of time for regular maintenance and
inspection of the scanner by a service engineer.
When the specified period has passed after the last regular
maintenance and inspection date,
LCD.
In this case, [maintenance] flashes on the second line in the
[Ready] screen.
Check the information and perform a regular maintenance and
inspection on the scanner by a service engineer.
For details about checking the information, refer to
the Information" (page 67).
For regular maintenance and inspection on the scanner by a
service engineer, contact your FUJITSU scanner dealer or an
authorized FUJITSU scanner service provider.
1
Start up the Software Operation Panel.
For details, refer to
(page
2
From the listing on the left, select [Device Setting 2] 
[Maintenance and Inspection Cycle].
flashes on the
"Checking
3
Select whether to enable or disable [Maintenance and
Inspection Cycle].
If you select [Enable], select the period of time for regular
maintenance and inspection of the scanner by a service engineer.
"8.1 Starting Up the Software Operation Panel"
156).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
207