A Shadow Appears At The Top Or The Bottom Of The Image - Fujitsu fi-7300NX Operator's Manual

A Shadow Appears at the Top or the Bottom of the Image

Check the following points
● Have you adjusted the offset (position to start the scan)? (page 208)
● Did you use the page edge filler function to fill in the shadow around the edge? (page 208)
If the problem persists, check the items in
first, then contact the distributor/dealer where you purchased this product. Or, make an inquiry by
referring to the contact information at the Contact for Inquiries section in Safety Precautions bundled with
this product.
●
Have you adjusted the offset (position to start the scan)?
Solution
In the [Offset] screen on the touch screen, adjust the offset for [Sub-scan ADF front] and
[Sub-scan ADF back].
The [Offset] screen can be displayed in the following procedure:
→ [Scanner Settings] → [Image] → [Offset]
When using the Software Operation Panel, refer to
Vertical magnification Adjustment] (page
●
Did you use the page edge filler function to fill in the shadow around the edge?
Solution
In the [Page Edge Filler Area] screen on the touch screen, fill in the shadow around the edge.
The [Page Edge Filler Area] screen can be displayed in the following procedure:
→ [Scanner Settings] → [Image] → [Page Edge Filler Area]
When using the Software Operation Panel, refer to
of Images [Page Edge Filler (ADF)] (page
For the settings in the scanner driver, refer to the scanner driver's Help.
Before You Contact the Scanner Service Provider (page 213)
Adjusting the Position to Start the Scan [Offset Setting/
265).
Removing Shadows/Streaks that Appear around Edges
268).
208
Troubleshooting