Fujitsu fi-7300NX Operator's Manual page 217

Setting Items
Paper Source/Feeding
(page 227)
Paper Protection (page
232)
Image (page 234)
Check connection (Ping)
(page 226)
Pre-Pick (page 227)
Retry Paper Feeding
(page 227)
Multifeed Detection (page
227)
Multifeed Detection Area
(page 229)
Intelligent Multifeed
Detection (page 230)
Manual Feeding (page
231)
High Altitude Mode (page
231)
Paper Protection (page
232)
Paper Protection (Touch
Screen Settings) (page
233)
Prioritize the touch screen
settings (page 233)
Automatic Page Size
Detection (page 234)
Page Edge Filler Area
(page 234)
Dropout Color (page 235)
Offset (page 236)
Magnification (page 237)
217
Description
Check the communication status between the scanner
and the connected computer.
Enable this to shorten the scanning time when
scanning continuously.
Specify the number of feeding retries when a
document is not fed from the ADF paper chute
(feeder).
Configure the settings to detect overlapped
documents during a scan.
Specify an area to detect overlapped documents.
Configure the setting to automatically ignore certain
patterns of overlapped documents when the setting
to detect overlapped documents is enabled.
Configure the settings when manually loading and
scanning one sheet at a time.
Enable this mode to use the scanner at an altitude of
2,000 m or higher.
Configure the setting to detect feeding errors.
Enable this option when you want some settings to
be prioritized over the settings for [Paper Protection]
and the Software Operation Panel.
When the scanner is set to detect the paper size
automatically, specify whether or not to optimize
(round up/down) the fractional part of the scanned
image.
Configure the settings to fill in the shadow or streaks
around the edge of the scanned image.
You can exclude a color from being scanned by
selecting either red, green, or blue (three primary
colors).
Specify a starting position for scanning.
Specify the magnification level for the feed direction.
Scanner Settings (Touch Screen)