Fujitsu fi-7300NX Operator's Manual page 199

●
Did you scan a thick document such as a plastic card?
Solution
Perform one of the following for a scan:
● Use the intelligent multifeed detection function.
● Disable the setting to detect overlapped documents by the ultrasonic sensor.
● Scan with Manual Single Mode.
●
Did you fan the documents before loading them?
Solution
Fan the documents.
For details, refer to
●
Have the documents just been printed out from a copy machine or a laser printer?
Solution
Fan the documents a few times to remove static electricity.
For details, refer to
●
Are the brake roller and pick roller installed correctly?
Solution
Install the brake roller and pick roller correctly.
For details, refer to
●
Are the brake roller and pick roller clean?
Solution
Clean the brake roller and pick roller.
For details, refer to
●
Are the brake roller and pick roller worn out?
Solution
Check the counters for the brake roller and pick roller in the [Consumable counters] screen on the touch
screen, and replace the brake roller and pick roller if necessary.
The procedure to display the [Consumable counters] screen is as follows:
→ [Cleaning & Maintenance] → [Consumable counters]
When using the Software Operation Panel, refer to
For details about replacing the brake roller and pick roller, refer to
and Replacing the Pick Roller (page
Preparation (page 76).
Preparation (page 76).
Replacing the Brake Roller (page 127)
Cleaning the Inside of the Scanner (ADF) with a Cloth (page
132).
199
and Replacing the Pick Roller (page
Checking the Sheet Counter (page
Replacing the Brake Roller (page 127)
Troubleshooting
132).
119).
259).