Fujitsu fi-7300NX Operator's Manual page 169

1
On the touch screen, press
[Wi-Fi Diagnosis].
2
On the [Wi-Fi Diagnosis] screen, check the display of [Network name (SSID)].
To check the network name that the computer is connected to, refer to the manual of your computer.
If the scanner and computer are connected to different networks, connect them to the same network.
Change the network that the scanner is connected to in the following procedure:
1
On the touch screen, press
2
On the [How to connect] screen, check that [Wi-Fi] is selected.
3
On the touch screen, press
4
On the [Access Point] screen, select the configuration method.
5
By following the window displayed, connect the scanner and the computer to the same wireless
access point.
●
Is the setting that does not permit communication configured on the wireless access point?
Solution
When the following are set on the wireless access point, take measures accordingly.
● Communication between wireless devices is disabled (for example, because of a privacy separator
function or a port separator function).
Enable communication between wireless devices on the wireless access point.
● SSID broadcast (for example, ANY connect) is disabled.
Enable SSID broadcast on the wireless access point. Or, configure the Wi-Fi settings manually.
● Protocol filter function is enabled.
Set the protocol on the wireless access point.
● The stealth function is enabled.
Disable the stealth function, and then use WPS to configure the Wi-Fi settings again. Or, configure the
Wi-Fi settings manually.
● MAC address filtering is enabled.
Set the MAC address of the scanner on the wireless access point, and then configure the Wi-Fi settings
again.
In addition, the channel may overlap with another wireless access point.
In this case, change the value of the wireless channel on the wireless access point.
For details about wireless access point settings, refer to the manual of your wireless access point.
→ [Scanner Settings] → [Network] → [Wi-Fi] →
→ [Scanner Settings] → [How to connect].
→ [Scanner Settings] → [Network] → [Wi-Fi] → [Access Point].
169
Troubleshooting