ELECTRO FREEZE SLX400E Operator's Manual page 36

ELECTRO FREEZE Soft Serve Models SLX400E, SLX500
9 Assembly
PIN - HANDLE
HANDLE - SIDE
Note: Item 10 center handle is longer.
Figure 9-4 Head Assembly
8. Install and lubricate the O-rings
(4, figure 9-4) (see O-ring Chart -
Replacement Parts Manual) on the
dispensing plungers (4,5) and insert
half-way into the head (1).
9. Install and lubricate the two 4-inch
head O-rings (2) .
10. Position the handles in the head
assembly by placing the 2 shorter
handles (9) on the sides and the
longest handle (10) in the center. Lock
in place with the handle pin (7).
Excessive force will damage the head.
Do not use tools to tighten.
26
(continued)
ROD - PLUNGER
O-RINGS - PLUNGER
KNOB - HAND
HANDLE - CENTER
HANDLE - SIDE
Important:
PLUNGERS - SIDE
PLUNGER - CENTER
PLUNGERS - SIDE
11. Install the dispensing head onto the
freezer by aligning the studs with the
holes in the head and sliding toward
the freezer. Tighten hand knobs
evenly, finger-tight only.
12. Install the plunger rods (6). The
nozzles (11) will be installed on the
mix outlet at the bottom of the head
after sanitizing.
O-RINGS - HEAD
O-RINGS - PLUNGER
HEAD - DISPENSE
— continued
184584