Instructions - ELECTRO FREEZE SLX400E Operator's Manual

8.2 Disassembly Instructions
It is important that the freezer be disassembled, washed, lubricated and sanitized
before operation. For maximum life on moving parts, disassemble and sanitize at the
end of every day of operation.
PIN - HANDLE
HANDLE - SIDE
Figure 8-2
1. If there is product in the freezer, refer
to Section 11, Closing Procedures,
11.2 Draining Product.
2. Remove plunger rods (6, figure 8-2)
by lifting up and swinging the bottom
out and down.
3. Remove the hand knobs (8) and
gently pull the dispensing head (1)
straight out.
184584
ELECTRO FREEZE Soft Serve Models SLX400E, SLX500
To avoid electrical shock or contact with moving parts, make
sure the control pad is "OFF" and that the power switch is
"OFF".
ROD - PLUNGER
O-RINGS - PLUNGER
KNOB - HAND
HANDLE - CENTER
HANDLE - SIDE
CAUTION
PLUNGERS - SIDE
PLUNGER - CENTER
PLUNGERS - SIDE
4. Remove the beater shaft (1, figure
8-3) from each cylinder. Then remove
breaker bar (1), scraper blades (3)
and shaft seal (3,4) from the beater
shafts. Remove the cup seals (4)
from the washer (5) on the shaft seal
assembly.
O-RINGS - HEAD
O-RINGS - PLUNGER
HEAD - DISPENSE
— continued
21