Uncrating And Inspection - ELECTRO FREEZE SLX400E Operator's Manual

ELECTRO FREEZE Soft Serve Models SLX400E, SLX500
2.1

Uncrating and Inspection

When the unit is received and while
the carrier is still present, inspect the
shipping carton for any damage that
may have occurred in transit. If the
SHOCKWATCH® label indicates red and/
or the carton is broken, torn, or punctured,
note the damage on the carrier's freight
Figure 2-1 Machine bolted to Shipping Base
Figure 2-2 Installing Mounting Legs or Casters
2
CAUTION
Be sure to properly support
the machine when removing
bolts and installing legs or
casters.
REMOVE HEX HEAD BOLTS
(4) AND FLAT WASHERS
CASTER WITH BRAKE
bill and notify the carrier's local agent
immediately.
1. Remove the carton from the pallet,
and move the machine as close as
possible to the permanent location.
2. Remove the shipping bolts on the
bottom of the freezer (figure 2-1) and
install either the legs or casters (figure
2-2).
REAR OF UNIT
FRAME WELDNUT
LEG SUPPORT
PALLET
NOTE: Screw casters
or legs all the way in
coupling, then adjust
REAR OF UNIT
to level side to side
LEG SUPPORT
CASTER WITHOUT
with a 1/4" slope to
BRAKE
the front.
REAR OF UNIT
LEG SUPPORT
SET SCREW
LEG COVER
LEG
184584