ELECTRO FREEZE SLX400E Operator's Manual page 34

ELECTRO FREEZE Soft Serve Models SLX400E, SLX500
8.3 Cleaning Instructions
Figure 8-7 Clean shaft seal, washer,
plunger, and nozzle
Figure 8-8 Clean beater shaft
Figure 8-9 Clean hopper and mix
feed port
Replace worn brushes. Use
only Electro Freeze original or
authorized replacement parts.
24
(continued)
c. The shaft seals, washers, plunger
o-ring grooves and nozzles (figure
8-7).
d. The beater shaft inside the front
collar and the hole on the rear flange
(figure 8-8).
3. Rinse parts with clear water and place
in sanitizing solution for 5 minutes.
Do not leave parts in sanitizer for more
than 15 minutes.
4. Place parts on a clean surface and
allow to air dry
5. Using a warm mild dish detergent
thoroughly brush:
a. the hoppers and the mix feed tube
ports from the hopper to the cylinders.
(figure 8-9).
b. the inside of the cylinders making
certain to clean the back walls with 4"
diameter brush provided.
c. the inside of the drain tube (figure
8-10). Dip the brush in the dish
detergent solution and force brush
into the drain tube until it stops -
repeat until clean.
6. Repeat step 5 using a brush to
rinse with water and then brush with
sanitizing solution.
7. Remove the drip tray and insert. Wash
in a warm dish detergent solution,
rinse with clear water and place in
sanitizing solution for 5 minutes.
8. Wash the outside of the freezer and
inside of the cabinet with a warm dish
detergent solution. Rinse with water
Figure 8-10 Clean inside of drain tube
Important:
184584