Mix Feed Tube - ELECTRO FREEZE SLX400E Operator's Manual

ELECTRO FREEZE Soft Serve Models SLX400E, SLX500
6 Operator Controls
In the "ON" position, power is supplied
to the beater motors. Use this
position to operate the freezer. Select
the "OFF" position for disassembly
and cleaning. See Operators Display
Menu for use of this switch in recording
cleaning cycles.
6.14

Mix Feed Tube

ROTATE
Figure 6-3
16
(continued)
12
Figure 6-2
The three piece mix feed tube (figure 6-4)
meters the correct amount of mix and air
going into the freezing cylinder.
1. To adjust the mix feed place your
MIX INLET PORT
thumb in the slot between the #3 &
INDICATOR
#0 and place your index finger in the
dimple between the #2 & #3. Gently
squeeze the outer sleeve and rotate
it till the arrow on the Mix Feed tube
is pointed to position #2 on the outer
sleeve.
2. The plastic mix feed regulator may be
adjusted between positions #1, 2 & 3
to obtain an optimum product overrun
and dispense speed.
MIX INLET PORT
3. The #3 setting will allow the least
overrun. The #1 indent setting will
allow the most air in the cylinder and
is used for a higher overrun.
4. During periods of idle or night
operation, place the mix inlet port to
the closed position #0. At this setting,
mix and air flow are shut off to the
cylinder.
If product is dispensed when the
regulator is in the "CLOSED" position,
a freeze-up will occur and may cause
damage to the freezer.
Important:
184584