Hinging The Rudder; Installing Vertical Stabilizer - Seagull Models BEAVER TURBIN Assembly Manual

HINGING THE RUDDER.

Glue the rudder hinges in place using
the same techniques used to hinge the ai-
lerons.
INSTALL RUDDER CONTROL HORN.
Repeat steps to install the rudder control
horn as same as steps done for ailerons.
Fiberglass control horn
Epoxy.
Rudder fiberglass control horn.

INSTALLING VERTICAL STABILIZER

1) Using a modeling knife, remove the
covering from over the precut hinge slot
cut into the lower rear portion of the fu-
selage.
Fill Epoxy
.
Remove covering.
21