Hinging The Rudder - Seagull Models MESSERSCHMITT Bf 109E 60 Assembly Manual

When you are sure that everything is
aligned correctly, mix up a generous
amount of 30 Minute Epoxy. Apply a thin
layer to the top and bottom of the stabi-
lizer mounting area and to the stabilizer
mounting platform sides in the fuselage.
Slide the stabilizer in place and realign.
Double check all of your measurements
once more before the epoxy cures. Hold
the stabilizer in place with T-pins or mask-
ing tape and remove any excess epoxy us-
ing a paper towel and rubbing alcohol.

HINGING THE RUDDER.

Glue the top two rudder hinges in place
using the same techniques used to hinge
the ailerons.
he lower hinge will be glued when the
in/rudder assembly is attached to the fu-
selage.
Epoxy
.
Epoxy
INSTALL RUDDER CONTROL HORN.
Repeat steps to install the rudder con-
trol horn as same as steps done for ailer-
Fiberglass control horn
Rudder iberglass control horn.
Epoxy.
23