Seagull Models BEAVER TURBIN Assembly Manual page 35

425mm
Cross brace wire.
Attach the longer support braces in the
holes in the cross braces using four M3 x
12 socket head cap screws, and four M3
lock nuts. Use a 2.5mm hex wrench to
tighten the hardware.
3 2
M3x12mm
1
Left
Right
Diagonal brace with aluminum bend piece.
Diagonal brace
AT POSITION 1.
Use the diagram to position the nylon
washers and the front diagonal brace
when installing the support braces to the
mounting brackets.
244mm
Cross brace wire.
Cross brace wire
Diagonal brace
Front
M3x15mm Socket Head Cap Screw
Diagonal brace with aluminum
bend piece
Nylon washer
Nylon washer
M3 locknut
35