Hinging The Rudder - Seagull Models Aviat A-1C Christen Husky 80 Assembly Manual

Aviat A-1C Christen Husky 80" wingspan size 15-20cc
6.
When you are sure that everything is
aligned correctly, mix up a generous
amount of 30 Minute Epoxy. Apply a thin
layer to the top and bottom of the stabi-
lizer mounting area and to the stabilizer
mounting platform sides in the fuselage.
Slide the stabilizer in place and realign.
Double check all of your measurements
once more before the epoxy cures. Hold
the stabilizer in place with T-pins or mask-
ing tape and remove any excess epoxy us-
ing a paper towel and rubbing alcohol.
7.
8.
26
Epoxy
.
Epoxy

HINGING THE RUDDER

Glue the top two rudder hinges in place
using the same techniques used to hinge
the ailerons.
he lower hinge will be glued when the
in/rudder assembly is attached to the fu-
selage.
1.
INSTALL RUDDER CONTROL HORN
Repeat steps to install the rudder control
horn as same as steps done for ailerons.
1.
Fiberglass control horn
2.
Instruction Manual.