Seagull Models BEAVER TURBIN Assembly Manual page 37

M3x15mm
NOTE : Leave the screw slightly loose until
the floats are attached to the fuselage.
AT POSITION 2.
Use the diagram to position the nylon
washers and the center diagonal brace
when installing the support braces to the
mounting brackets.
240mm
Cross brace wire.
Cross brace wire
Diagonal brace
Front
M3x15mm Socket Head Cap Screw
Nylon washer
Nylon washer
M3 locknut
Repeat these steps for opposite position.
Attach the cross brace wire and mount-
ing bracket to the diagonal brace using an
M3 x 15 socket head cap screw, two nylon
washers, aluminum piece and an M3 lock
nut.
Cross brace wire
Diagonal brace
Aluminum piece
Front
M3x15mm Socket Head Cap Screw
Nylon washer
Nylon washer
M3 locknut
37