Platform Control Indicator Panel - JLG Toucan 800 Operation And Safety Manual

8. Auxiliary Power Button
Once the electrical power is cut due to excessive
battery discharge (80%), the Auxiliary Power
Button can be pressed to use the remaining
battery charge to travel to the charging station.
NOTE: The button must be actuated and held BEFORE the
controls are enabled and the desired movement is
controlled. An intermittent acoustic signal is
actuated when the button is actuated.
IMPORTANT
A TOTAL DISCHARGE WILL RESULT IN IRREVERSIBLE DAMAGE
TO THE BATTERY.
9. Drive Control Joystick
Move the controller forward to drive forward.
Move the controller backward to reverse.
10. Drive Speed Selector Switch
1st gear or slow speed
2nd gear or climbing speed (max. 20%)
3rd gear or high speed
11. Horn
Sounds when the button is depressed.
12. Steering control
Push the right side of the thumb switch to steer the
wheels to the right. Push the left side of the thumb
switch to steer the wheels to the left.
31210031
SECTION 3 - MACHINE CONTROLS AND INDICATORS

Platform Control Indicator Panel

Figure 3-5. Platform Control Indicator Panel
1. Tilt Indicator Light and Alarm
2. Slack Chain Indicator Light and Alarm
3. Overload Indicator Light and Alarm
4. Unauthorized Movement Indicator
5. Power Enable Indicator
1. Tilt Indicator Light and Alarm.
Excessive tilt. Red light and audible alarm
indicates the rated slope has been exceeded.
2. Slack Chain Indicator Light and Alarm.
Slack lifting chain. Red light and audible alarm
indicates slack chain condition has been detected.
3. Overload Indicator Light And Alarm
Flashing red light and audible alarm indicates the
platform has been overloaded (Toucan 800 only).
4. Unauthorized Movement Indicator.
Orange light which indicates the machine is in a
configuration where the activation of movement is
not permitted.
5. Power Enable Indicator.
Green light indicates that the controls are ready.
– JLG Lift –
.
3-7