Raising And Lowering The Mast - JLG Toucan 800 Operation And Safety Manual

Figure 4-1.
Forward
1. Position the DRIVE SPEED selector to 1st gear
( ), 2nd gear (
2. Match the black and white direction arrows on
both platform control panel and chassis to
determine the direction the machine will travel.
3. Depress footswitch.
4. Push the controller forward within 5 seconds after
the footswitch has been depressed.
Stopping
Stopping is accomplished by slowly returning the
DRIVE controller to the neutral position. The brakes will
apply automatically.
Reverse
Traveling in reverse is accomplished the same way as
traveling forward except for pulling the DRIVE
controller toward the operator to reverse (REV).
Steering
Steering is accomplished by pressing the left side of
the THUMB switch (on top of the controller) to steer to
the left or the right side of the THUMB switch (on top
on the controller) to steer to the right.
31210031
Grade and Side Slope
) or 3rd gear (
TO AVOID TIP OVER, LOWER PLATFORM TO GROUND LEVEL.
). THEN DRIVE MACHINE TO A LEVEL SURFACE BEFORE RAISING
MAST.
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY
CONTROL
PLATFORM MOVEMENT DOES NOT RETURN TO THE 'OFF' OR
NEUTRAL POSITION WHEN RELEASED.
IF THE PLATFORM DOES NOT STOP WHEN A CONTROL SWITCH
OR LEVER IS RELEASED, REMOVE FOOT FROM FOOTSWITCH
OR USE EMERGENCY STOP SWITCH TO STOP THE MACHINE.

Raising And Lowering The Mast

Raising the mast :
1. Depress footswitch.
2. Pull the mast function control switch toward the
operator to raise the mast within 5 seconds after
the footswitch has been depressed.
3. Adjust the speed movement using the function
speed control.
Lowering the mast :
1. Depress footswitch.
2. Push the mast function control switch away from
the operator to lower the mast within 5 seconds
after the footswitch has been depressed.
3. Adjust the speed movement using the function
speed control.
– JLG Lift –
SECTION 4 - MACHINE OPERATION
LEVER OR TOGGLE SWITCH CONTROLLING
4-3