Table of Contents
Advertisement
Tie Down
1. Place the machine in the stowed position.
2. Remove all loose items from the machine.
3. Chock wheels in both directions.
4. Secure the chassis using straps or chains of
adequate strength and attached to the designated
tie down points.
Toucan 800
Toucan 870
31210031
SECTION 4 - MACHINE OPERATION
4.9
LOADING AND UNLOADING
Using a fork lift truck
Toucan 800
Toucan 870
Figure 4-2. Position of the forks
VERIFY THE CAPACITY OF THE FORKLIFT TRUCK AND OF ITS
EQUIPMENT. FORK LIFT ONLY AT THE DESIGNATED POINTS. ANY
OTHER POSITION OF THE FORKS WILL CAUSE THE MACHINE TO
TIP OVER. NOBODY MUST BE ON THE PLATFORM OF THE
MACHINE DURING LOADING AND UNLOADING OPERATIONS.
THE WORK PLATFORM MUST BE KEPT AS NEAR TO THE
GROUND AS POSSIBLE DURING FORK LIFT OPERATION.
Using a winch for loading
If the work platform cannot be loaded safely using the
work platform controls, use a winch (release brakes
prior to the operation).
CHECK THE CAPACITY OF THE EQUIPMENT USED. PLACE THE
MACHINE IN TOWING MODE (SEE § 4.7) FOR THE LOADING AND
UNLOADING PROCEDURES. NOBODY MUST BE IN THE
PLATFORM DURING THIS OPERATION.
– JLG Lift –
4-9
Advertisement
Table of Contents
