Verification Of The Tilt Alarm Setting - JLG Toucan 800 Operation And Safety Manual

11. Verification Of The Tilt Alarm Setting

Interval - Check after every 6 months of operation.
a. Place machine on a known level surface.
b. Position the selector switch to "Ground controls".
c. Chock both rear wheels.
d. Place a spirit level (digital display) on the chassis
positioned lengthways.
e. With a jack of appropriate capacity, lift the front
of the chassis to tilt level specified in Table 8.1
and ensure that :
• An acoustic alarm sounds when the chassis is
tilted at its max value.
• The corresponding LED lights up on the
platform controls.
f. Repeat steps (d) to (e) with the front wheels
chocked and lift at the rear.
g. Place a spirit level (digital display) across the
chassis.
h. With a jack of appropriate capacity, lift the right
hand side of the chassis to tilt level specified in
Table 8.1 and ensure that :
• An acoustic alarm sounds when the chassis is
tilted at its max value.
• The corresponding LED lights up on the
platform controls
i. Repeat steps (g) and (h) with the left side of the
chassis lifted.
j. Remove the blocks.
31210031
SECTION 8 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
– JLG Lift – 8-13