Turntable Lubrication; Lifting Chains Lubrication; Mast Section Lubrication; Wheel Bearing & Steering Knuckle Lubrication8-9 - JLG Toucan 800 Operation And Safety Manual

3. Turntable Lubrication

Bearing Track :
Lube Point - Grease Fitting
Lube - TYPE E
Interval - Every 250 hours of operation.
Grease the bearing track using a grease pump.
Turntable Teeth :
Lube Point(s) - Coat each tooth.
Lube - TYPE C
Interval - Every 1000 hours of operation
• Remove the protection covers.
OPERATION MUST BE PERFORMED ON FLAT AND HORIZONTAL
GROUND, IN AN AREA ALLOWING FULL ROTATION OF THE
STRUCTURE.
• Apply new grease with a brush on the turntable
teeth. Rotate the structure to ensure all the teeth
have been greased.

4. Lifting chains lubrication

Lube - TYPE D
Interval - every 125 hours or once every 30 days of
operation.
Comments - Lubricant can be applied manually with a
brush or by spraying. Apply lubricant :
- Longitudinally : in areas where joints are under small
load to facilitate penetration of the lubricant.
- Transversally : between the plates to enable the
lubricant to reach the joint and between the internal
plates and the rollers.
31210031
SECTION 8 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE

5. Mast Section Lubrication

Lube - TYPE B
Interval - every 125 hours of operation or after each
cleaning.
Comments - Clean the inside wall of mast to remove
the old grease. Lubricate the mast inside wall using a
brush.
6. Wheel Bearing & Steering Knuckle Lubrication
Lube point(s) - 2 Grease Fittings
Lube - TYPE E
Interval - every 125 hours of operation.
Comments - One fitting on each hub and one fitting
on each knuckle.
– JLG Lift – 8-9