Fujitsu ETERNUS DX60 S3 Operation Manual page 72

4. Component Expansion/Function Enhancement
Adding Servers
■
CA Port Parameter Settings
Set the CA port parameters if the port information of the ETERNUS DX needs to be changed because of the server
that is to be added.
When any server is already connected, make sure that the server will not be affected by the change.
For details on how to change the settings, refer to "Configuration Guide (Web GUI)".
■
CA Port Group Creation
Create a CA port group for a host to access the ETERNUS DX.
A CA port group is a group of host interface ports that have the same interface and connect to the specific host
group.
The procedure to create a CA port group is as follows:
1
Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen, and then click "Port Group"
in [Category].
The [CA Port Group] screen appears.
2
In [Action], click the [Create CA Port Group] that corresponds to the host interface of the port group that is
to be added.
The [Create CA Port Group] screen appears.
3
In the [Create CA Port Group] screen, enter the name of the CA port group that is to be created, select the
checkbox for the ports that are to be registered in the CA port group, and click the [Create] button.
A confirmation screen appears.
4
Click the [OK] button.
The CA port group is created and the setting completion screen appears.
5
Click the [Done] button.
The screen returns to the [CA Port Group] screen.
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
72
Copyright 2018 FUJITSU LIMITED
P3AM-9012-08ENZ0