Fujitsu ETERNUS DX60 S3 Operation Manual page 60

4. Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in the
2nd and 5th holes on the rear rack pillars above the base line to fasten the rack rails.
Sixth screw
(M5 screw)
First screw
(M5 screw)
Fifth screw
(M5 screw)
Second screw
(M5 screw)
(3)
Tighten the M4 screws of the rack rails that were slightly unscrewed in
(4)
Install the drive enclosure in the rack.
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
Front view of drive enclosure
[Left]
2U
Bottom position of
drive enclosure
Rack rail
Rear view of drive enclosure
[Left]
2U
Bottom position of
drive enclosure
Rack rail
Do
When installing or removing the drive enclosure to or from the rack, make
•
sure that the sides and the bottom of the drive enclosure are held by two or
more people. Failure to do so may cause injury.
Copyright 2018 FUJITSU LIMITED
[Right]
Sixth screw
(M5 screw)
First screw
(M5 screw)
[Right]
Fifth screw
(M5 screw)
Second screw
(M5 screw)
60
Step (1).
P3AM-9012-08ENZ0