Replacing The Processor - Gateway E-9220T User Manual

Replacing the processor

The server is compatible with Intel
and Pentium D (800 MHz FSB) processors with 256 KB (Celeron), 1 or 2 MB (Pentium 4),
or 2×1 MB (Pentium D), L2 caches. The server automatically detects the processors each
time you turn it on. Whenever you install new processors, you should first install the most
current version of the BIOS. For more information, see
Warning
Caution
To replace the processor:
1
Install the most current BIOS version. For more information, see
on page 67.
2
Follow the instructions in
3
Follow the instructions in
4
Follow the instructions in
5
Loosen the four captive heat sink screws (one on each corner).
®
Celeron (533 MHz FSB), Pentium 4 (800 MHz FSB),
Processors and heat sinks may be hot if the computer has been
running. Also, there may be sharp edges on the heat sinks. Consider
wearing protective gloves.
A heat sink must be installed on the processor. Installing a processor
without a heat sink could damage the processor.
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Removing the processor air duct" on page
www.gateway.com
Replacing the processor
"Updating the BIOS" on page
"Updating the BIOS"
30.
33.
67.
29.
51