Rps > [1] Rps Passcode Menu Parameters; Rps > [2] Rps Phone Number Menu Parameters; Rps > [3] Rps Ip Address Menu Parameters - Bosch B6512 Installation Manual

Control Panels
4.
5.
SIM PIN
1.
2.
3.
4.
5.
20.1.9 [3] RPS > [1] RPS Passcode menu parameters
The control panel verifies the remote programming software at the central station has valid
access before connecting using the RPS passcode. In this menu, you can program the RPS
passcode.
RPS Passcode
1.
2.
3.
4.
5.
6.
20.1.10 [3] RPS > [2] RPS Phone Number menu parameters
The RPS Phone Number is the number the control panel dials to contact RPS or the Installer
Services Portal programming tool (available in Europe, Middle East, Africa, and China). In this
menu, you can program the RPS phone number.
RPS Phone Number
1.
2.
3.
4.
5.
6.
20.1.11 [3] RPS > [3] RPS IP Address menu parameters
The control panel can use a network hostname or an IPv4 address to call RPS or the Installer
Services Portal programming tool (available in Europe, Middle East, Africa, and China). In this
menu, you can program the IPv4 address or hostname for RPS or Installer Services Portal
programming tool communication.
RPS IP Address
1.
2.
3.
Bosch Security Systems, Inc.
Delete existing characters, if necessary, and then enter the new characters.
Press Save or Enter. The keypad shows Parameter saved.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [2] Cellular > (choose the SDI2 cellular
module or plug-in module) > [4] SIM PIN. The keypad shows the current configuration.
Press Edit or Enter to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press Save or Enter. The keypad shows Parameter saved.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [3] RPS > [1] RPS Passcode.
Press Edit or Enter to edit the RPS passcode.
Delete the existing number, if necessary, and enter the new number.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [3] RPS > [2] RPS Phone Number.
Press Edit or Enter to edit the RPS phone number.
Delete the existing number, if necessary, and then enter the new number.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [3] RPS > [3] RPS IP Address.
Depending on keypad model:
Press Edit as IPv4 for an IP address, or Edit as Name for a hostname.
-or-
Installation Manual
Keypad Installer menu | en 109
2018.07 | 16 | F.01U.287.180