Appendix A: Linking To A Development Pc - ICPDAS PDS-811 User Manual

Programmable Device Server with I/O Expansion Slot(s)

Appendix A: Linking to a Development PC

Step 1: Connect the download-cable (CA0910), between the PDS-8x1 controller and COM 1 of the
development PC.
1-1: Connect the connector of CA-0910 download cable to your host computer.
1-2: Wire the CA-0910 to PDS-8x1 controller, as follows:
Connect the CA-0910.TX with PDS-8x1.TxD
Connect the CA-0910.RX with PDS-8x1.RxD
Connect the CA-0910.GND with PDS-8x1.GND
Step 2: Set the Init/Run Switch in "Init Mode" position.
Step 3: Supply +24 V
DC
Refer to below illustration for how to perform the above procedure.
3
(+10 ~ +30 V ) power to the PDS-8x1 controller.
DC
1
PDS-8x1 Series User Manual, Version 1.1.2, Apr. 2015
2
- 95 -