Config - ICPDAS PDS-811 User Manual

Programmable Device Server with I/O Expansion Slot(s)

6.3.22 CONFIG

This command is used to clear the settings in the EEPROM.
Effect: Immediate
Command Arguments
config = RESET
※When "Config=RESET" is used, the Password, Alias and IPFILTER settings will also be cleared,
but the IP/MASK/GATEWAY addresses will not.
※The SystemTimeout setting is also cleared to 0 by the "config=RESET" command, you have to
configure the SystemTimeout value again. The default factory setting of SystemTimeout value
should be 300000 ms (= 300 seconds).
Figure 6-3.22: The following is an example of a CONFIG configuration.
Description
Clears the settings in the EEPROM.
After reboot, the firmware will use the new (default) settings on
EEPROM.
Note: "RESET" MUST be in capital letters.
PDS-8x1 Series User Manual, Version 1.1.2, Apr. 2015 - 93 -