Names And Functions; Analog Input Unit (Type: Na0Ax06-Mr) - Fuji Electric NA0AX06-MR User Manual

Section 2 Specifications

2-3 Names and Functions

2-3-1 Analog input unit (Type: NA0AX06-MR)

(1) Names
The jumper pins in the analog input unit are used to change the analog signal range and digital value range. Therefore, remove
the upper cover and control board when setting the jumper pin.
2) Terminal block
Expansion connector (IN)
1) Status indication LED
2) Terminal block
3) JP1
Pin layout of control board
(When the upper cover is removed)
<Notes on mounting/removing the upper cover and control board>
• When handling the analog unit, remove it from the control panel, turn off the power, and disconnect other units.
• The procedure for handling the upper cover and printed circuit board, see "Appendix 1 Unit Handling Procedure."
• Before mounting/removing the upper cover or handling the printed circuit board, be sure to eliminate static electricity.
Expansion connector (OUT)
Nameplate
4) JP3
5) JP7 (CH3)
5) JP6 (CH2)
Pin layout of I/O board
(When the control board is removed)
2-15
5) JP5 (CH1)
5) JP5 (CH0)
4) JP2
5) JP8 (CH4)
5) JP9 (CH5)