Fuji Electric NA0AX06-MR User Manual page 27

Section 2 Specifications
(2) Functions
1) Status indication LED
Status indication LED
PWR of analog output unit
2) Terminal block
These are terminals for 24V DC power supply to operate the analog unit and analog input signal.
3) JP1: Digital value range selection
This jumper pin is used to set the digital value range.
Digital value range
-8192 to 8191
0 to 16383
4) JPA and JPB: Analog output range selection
Signal range JPA setting
0 to 10V
-10 to 10V
0 to 5V
-5 to 5V
0 to 20mA
-20 to 20mA
0 to 10mA
-10 to 10mA
* When handling the setting pins on the printed circuit board, be sure to turn OFF the unit power. Securely mount them by using
tweezers.
Status Specification
ON (red) While 5V DC power is normally supplied.
* For the wiring method, see "2-4 Wiring."
JP1 setting
U
B
U
B
JPB setting
2-18