Notes To Owners Of Multi-Gauge And Sentorr - Varian XGS-600 Instruction Manual

Description
Read Setpoint Off
Delay time
Calibrate CNV
Set Atmosphere Value
Read CNV gas type
Set CNV gas type

Notes to owners of Multi-Gauge and SenTorr:

❑
Most commands used by Multi-Gauge and SenTorr are still found in this protocol.
❑
Commands which apply to Multi-Gauge/SenTorr but do not apply to the XGS are
ignored by the XGS-600. There is no response and no error message.
❑
Any commands (ex. # 56-59) referring to a gauge or sensor type that is not supported
by the XGS-600 result in ?FF error message.
B-8
XGS-600 Gauge Controller
Table B-1 Serial Command Set (Continued)
Command
#aaFh
where h is setpoint
number 1 - 8
CNV Commands
#aaA1cn
where cn is a CNV
#aaA3x.xxxE+xx
where pressure is local
atmospheric value.
#aa4Ecn
#aa4Fcnx
where:
x=0 for Nitrogen/Air
x=1 for Argon
NOTE
All alpha characters must be upper case.
Response from
XGS-600
>xx
where x.x is delay in
seconds
>
>
>x
where:
x=0 for Nitrogen/Air
x=1 for Argon
>
Notes
This command has the
same function as CAL
on the main screen, i.e.
used for both
atmosphere and
vacuum calibrations.
Same as System Setup
screen Atmosphere
Value.