Feature Compatibility Table - Varian XGS-600 Instruction Manual

SenTorr provide true isolated relay outputs with access to C, NC and NO contacts.
SenTorr uses terminal block connectors while MultiGauge uses a 25-position Dsub.
❑
XGS-600 is not available in a Black Box version with a remote mountable display.
Table A-10 list the features compatible for the MultiGauge and SenTorr units.
Feature
Hot Filament All
Gauges
Cold Cathode IMG100
Gauges
IMG300
(UHV-IMG)
Convection 2 ch Convection
Gauges Bd using (2)
Dsub9
CDG's Not supported
Rem I/O Uses Fire-wire
conn on each
board
All control
inputs are active
LO, no isolation
Analog Output In Fire-wire
conn of each Bd
Conv Bd also
provides access
pin in Dsub9
Set Points Std 8 setpoints,
2 per ch using
open collector
drivers in Dsub9
XGS-600 Gauge Controller
Table A-10 Feature Compatibility Table
XGS-600 MultiGauge
All
IMG100
UHV-IMG
525CCG
4 ch TC Bd using
DsuB37
2 ch ConvecTorr
Bd using (2) Dsub9
(2) Dual Ch CDG
Bds
Needs optional
Remote I/O Bd
using Dsub37
Uses opto-isolated
active HI inputs
Micro phone jack
on each Bd
2ch and 4ch Conv
bds provide access
in Dsub conn
Optional 8
setpoints using
relays using
Dsub25, access to
C,NO,NC contacts
SenTorr BA or
UHV
All n/a
n/a 525CCG
2 ch ConvecTorr 2 ch ConvecTorr
using (2) Dsub9 using (2) Dsub9
2 ch TC 2 ch TC
n/a n/a
Micro phone jack Micro phone jack
for IG control for IG control
Uses opto-isolated Uses opto-isolated
active HI inputs active HI inputs
Micro phone jack Micro phone jack
Optional 4 Optional 4
setpoints using setpoints using
relays using term relays using term
block type conn,
block type conn,
access to access to
C,NO,NC contacts C,NO,NC contacts
SenTorr CC
A-9