Software Versions Screen - Varian XGS-600 Instruction Manual

ATMOSPHERE VALUE
(Convection Boards)
SERIAL MODE
SERIAL BAUD RATE
RS485 ADDRESS
RESET SCREEN
EXIT

Software Versions Screen

This screen shows the software versions on a board-by-board basis.
To open this screen select RESET SCREEN on the System Setup screen.
SYSTEM RESET
EXIT
XGS-600 Gauge Controller
Sets the Atmosphere value to be used in Convection gauge
calibration. See "Main Screen" on page 3-3 for the calibration
procedure.
Select between RS232 or RS485 serial transceivers. RS232 and
RS485 have separate outputs on the rear panel Serial connector
(see Appendix Appendix A. "XGS-600 Gauge Specifications" on
page A-1).
Selects between baud rate options: 9600 (default) and 19200.
Set the RS485 address (default 00) as used in the first two
characters of all serial protocol commands (see
Appendix Appendix B. "Serial Commands" on page B-1).
Select to open the Software Versions screen which incudes the
system reset function (page 3-15).
Select to return to the Main Screen (page 3-3).
Figure 3-7 Software Versions Screen
Use this to perform a full reset of user-defined variables, reverting
the system to as-shipped (factory-set) state.
Select to return to the Main Screen (page 3-3).
3-15