How To Program An Abort Switch - Notifier NFS-640 Programming Manual

Appendix A: Releasing Applications

How to Program an Abort Switch

The following contains information needed to program an Abort Switch for a monitor module.
66
www.PDF-Zoo.com
Description A monitor module, connected to a UL-listed abort station (such as the Notifier
NBG-12LRA), that you use as an abort switch for a Releasing Zone. You can
program multiple monitor modules with the
like multiple conventional abort switches on a conventional zone.
How to 1. Select a monitor module that you want to use as an Abort Switch (refer to
program "How to Modify or Delete a Point (2 =
2. Select the
3. Select the Releasing Zone (R0-R9) for your releasing application.
4. Press the
Program Change screen.
5. Select the type of Abort Switch for your releasing application (refer to "How
to Program an Abort Switch" on page 54).
Example
A programming example of a monitor module programmed as an Abort Switch for
Releasing Zone R5.
Figure 12 Monitor Module Configured as an Abort Switch
Type Code.
ABORT SWITCH
PROGRM ABORT_SWITCH MODULE ADDR 2M101
R1 __ __ __ __
key to save, then press the
ENTER
SYSTEM SYSTEM
NORMAL ACTIVATED
Type Code
ABORT SWITCH
NBG12LRA
station with
Abort Switch
NFS-640 Programming Manual P/N 51333:B 10/03/2003
How to Program a Releasing Zone
Type Code that work
ABORT SWITCH
)" on page 21).
POINTS
Type Code selection:
ABORT SWITCH
2M101
Releasing Zone selection (R1 shown)
key until you return to the
ESC
Monitor
Detector
Module
R05
Control
B01
Module