Table of Contents
Advertisement
INERTIA-2464 Technical & Programming Manual
TO ENTER PROGRAM MODE
Hold the door switch down while pressing the following buttons in order shown to enter programming mode.
PREVIOUS
PROGRAMMING MODE
The liquid crystal display will display all messages and prompts required to program the 2464
ONLY the "PREVIOUS","NEXT","SELECT","EXIT" AND "ENTER" keys are used in programming mode. All
other keys will give an error beep and are ignored.
You must exit programming mode if any other panel functions are to be performed.
Note:
Refer to appendices for detailed explanation of functions
PROGRAMMING HIERARCHY
ZONES
STD LATCHING
STANDARD LATCHING AVF
NON LATCH
NON LATCH 20S
TIME DELAY 10S
TIME DELAY 20S
TIME DELAY 30S
TIME DELAY 40S
TIME DELAY 50S
TIME DELAY 60S
NEXT
SELECT
EXIT
SAVE CHANGES
YES
ZONES
GLOBAL
TYPE
(RESETTING)
(RESETTING)
(RESETTING)
(RESETTING)
(RESETTING)
(RESETTING)
Copyright (c) 1996, INERTIA FIRE SYSTEMS
EXIT
NO
RELAY
PRINT
OUTPUT
INDICATE
I BELL
IB GENERAL
IBG ACF OUT
IBGA BRIGADE 1
IBGA BRIGADE 2
IBGA BRIGADE 1 & 2
Page 29
PROGRAM MODE
ENTER
Advertisement
Table of Contents
