Server Simms Requirements; Memory Configuration Guidelines - Digital Equipment 3100R Series Service Maintenance Manual

FRU Replacement

Server SIMMs Requirements

Supported SIMMs
Supported densities
Minimum server memory supported
Maximum server memory
supported

Memory Configuration Guidelines

The memory configuration guidelines for
•
Each memory bank on the processor module must contain two SIMMs
which must be the same size and type.
•
Install memory starting at Bank 0, then Bank 1, then Bank 2, and Bank 3
last.
•
Add SIMMs in multiples of two to fill up a bank.
•
EDO and Fast-Page memory can be mixed by bank only.
5-38
NOTE : Before you begin, create a SCU diskette using
Quick Launch. You must run the SCU after installing any
memory upgrade. This allows the server to recognize
the new memory configuration.
36-bit SIMMs, 60 ns access time, EDO or
Fast-Page memory
32, 64, or 128 MB of EDO or Fast-Page
memory (refer to the memory configuration
guidelines for additional information)
64 MB
1 GB
DIGITAL Server are as follows:
the