Run The Scu - Digital Equipment 3100R Series Service Maintenance Manual

Run the SCU

Power up and boot the server from the SCU diskette. The SCU enables you to
check or change the server's configuration. Run the SCU to configure the server for
the new processor or processor module.
To start and run the SCU:
1. Insert the SCU diskette into drive A and turn on the server. The diskette should
boot automatically.
2. When the SCU title appears, press any key to continue. Afterwards, follow
the instructions on screen to access the SCU main menu.
3. From the main menu, press the up or down arrow to highlight an item and
then press Enter to select it. Press F1 at any time for help about a selection.
4. From the main menu select
Edit Details.
For example: If you install a video option card, select the Advanced Control
Group and disable the Embedded - PCI VGA controller .
5. Make sure that the boot option is drive "A: then C:"
6. Select Save and Exit to configure the server for the processor module.
7. When complete, remove the SCU diskette from drive A.
Refer to Chapter 2, "Server Software and Utilities," for additional information on
running the SCU.
Configure Computer
Processor Module Upgrades
and then
View and
6-23