Mc3000 Display In Auxiliary Mode - Lenze AC Tech M3103S Installation & Operation Manual

13 .2 .4 MC3000 DISPLAY IN AUXILIARY MODE
If the ENTER key is held down, the display will enter the auxiliary mode and cycle between
two displays: a CONTROL display that indicates the control source (LOCAL, REMOTE, or
SERIAL), AUTO or MANUAL mode, and the speed reference source, and a TIME display
that indicates total elapsed run time . When the ENTER key is released, the display will
return to the previous screen . Examples of the auxiliary mode displays are shown below:
The table below shows the possible SPEED REFERENCE SOURCE indications for the
CONTROL display in the auxiliary mode:
DISPLAY
KEY
VDC
IDC
SP#1 - SP#4
MKB
AKB
28
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
CONTROL AUTO/MAN
SOURCE MODE
LOCAL -- AUTO -- IDC
CONTROL DISPLAY
TIME:
TIME DISPLAY
SPEED REFERENCE SOURCE TABLE
DESCRIPTION
KEYPAD -  and  keys.
0 - 10 VDC analog input at TB-5A (In PID mode, this indicates that
the SETPOINT reference is a 0-10 VDC signal).
4 - 20 mA analog input at TB-5B (In PID mode, this indicates that
the SETPOINT reference is a 4-20 mA signal).
PRESET SPEED #1 - PRESET SPEED #4
MANUAL KEYBOARD - The  and  keys are used for speed
control. This occurs in PID mode when the drive is put into HAND
(open-loop) mode.
AUTO KEYBOARD - The  and  keys are used as the PID
SETPOINT reference. This occurs in PID mode when the drive is
put into AUTO (closed-loop) mode.
M301L
SPEED
REFERENCE
SOURCE
487.2 HRS