Lcd Display - Lenze 9215 Operating Instructions Manual

Parameter setting
1.
PRG
1.1.
Key
PRG
+ SH
+ SH
SH + PRG
STP
SH + STP
Note
•
For the execution command SH+PRG and the enable command SH+STP first
press the SH key and hold, than press the PRG or STP key.
•
When inhibiting the controller by pressing the STP key, it must be enabled
again by using the SH+STP command. Only then can it be
enabled via terminal 28 or interface.
1.2.
The LCD display constists of two lines of 16 characters each. In the
upper line, code no. and parameter are displayed. The arrow >
shows the present level (code or parameter level), which can be
changed when pressing the
codes or parameters are explained.
-Arrow for code level-
↓
-Code no.-
> C 0 0 1
O p e r a t i n g
40

LCD display

SH STP
Key functions
Function
Change between code and parameter level
Increase displayed value
Rapid increase of displayed value
Reduce displayed value
Rapid reduction of displayed value
Execute change. Reset after fault indication
Inhibit controller (see note below)
Enable controller
Plain-text display
or
-Parameter-
- 0 -
-Explanatory text-
Ready (green)
Curr. limit I
max
Im pulse inhib it
(yellow )
Keys
key. In the lower line, the
m o d e
(red)
Fehler! Es
ist nicht
möglich,
durch die
B

b it