Set; Range - Digi PortServer/8 User Manual

Syntax:

set

The set command is used to set or display various PortServer system and port parameters. The
different tables that can be substituted for tablename are:
altip arp
host route
users
flow keys
logins ports
Each of the tables will have their own options, as outlined in the following descriptions.

Range

As a part of any of the set commands, you have to specify which port or table entry the com-
mand is to affect. In the preceding list of tables, the names above the horizontal line are set
command variables referenced by their table index, while the items below the line may be
specified for modification by port number. If you do not specify a range, the set commands in
this section will affect only the port you are logged in from.
Specify the table entry, or a range of table entries, with the range option, in one of three formats:
(command) range= singleport#
set
This tells the set command that the rest of the command affects the port number singleport#.
(Type in the rest of the command after the value for singleport#.)
(command) range= startport#
set
This tells the set command that the rest of the command affects the port numbers startport#
through endport# . (Type in the rest of the command after the value for endport#.)
It is possible combine the preceding two methods, separated by commas:
(command) range= port# , startport#
set
Page 38 Ÿ Command Reference
tablename [options . . . ]
config
terms
line
endport#
-
set
The variables in these tables are refer-
enced by their table indexes.
The variables in these tables are refer-
enced by port numbers.
endport# , port#
-