Altip - Digi PortServer/8 User Manual

altip

Syntax:
set altip
set altip ip=
set altip rmip=
set altip rmrange range=
The altip command allows you to telnet to a port or huntgroup using an IP address (or host
name). You must assign an additional IP address to the port or hunt group.
Options are:
group ip
set altip range=
If the set altip command is entered with no options, or no options other than a
range, the current altip table entries for that range are displayed. ( set altip with
no range prints the entire table.)
ipaddr group= port# | group#
set altip ip=
This form of the command makes a new entry, or changes an existing entry. If the IP
address matches an existing entry, that entry will be modified. Otherwise a new
table entry will be created.
The IP address must be on the same network (or subnetwork) as the main IP address
of the PortServer. The group may be a port number or a group number. (See set ports
group=on page 52 for information on how groups of ports are assigned.)
set altip rmip=
This form of the altip command remove entries from the table by ip address.
set altip rmrange range=
This form of the altip command remove entries from the table by index numbers.
Up to 16 alternate IP address may be assigned.
Also see PortServer Port Numbers on page 101.
Page 40 Ÿ Command Reference
[ range= range]
ipaddr group= port# | group#
ipaddress
range rmip
range
ipaddress
range
range
rmrange save