Snmp - Digi PortServer/8 User Manual

Syntax:

snmp

The snmp command is used to configure and enable/disable snmp. The snmp community is
"public." Snmp sets are not supported.
| off
snmp run=on
This starts or stops the SNMP daemon. Default is Off.
snmp auth_trap=on
This configures SNMP to send or ignore authentication traps when an authentication
error occurs. Default is Off.
snmp trap_dest
This configures SNMP to send all traps to the IP address given.
snmp location="
This gives SNMP the value of system.sysLocation, which is a text string that
describes the location of the box in a form meaningful to the user. This parameter is
optional. Note that the entry must be surrounded by quotation marks if there are
spaces used in the text.
snmp contact="
This gives SNMP the value of system.sysContact, which is the name of the person
responsible for managing the PortServer. This parameter is optional. Note that the
entry must be surrounded by quotation marks if there are spaces used in the text.
Entering snmp with no options prints out the current configuration.
Also see SNMP Protocol on page 67.
Page 58 Ÿ Command Reference
[ run=off | on ] [ auth_trap=off | on ] [ trap_dest= ipaddress]
[ location= PortServer's location]
| off
IP address
=
location of PortServer "
Person to contact "
snmp