Digi PortServer/8 User Manual page 35

In the modem setup example (page 17), the connection from
Set Modem
for Hardware the PortServer to the modem was set to use RTS/CTS hardware
Handshake handshaking. Here, Betty tells the modem to use the same, by
typing:
on Serial
Connection
AT&K3
(Betty is connected directly to the modem, so there are no com-
mand prompts.)
Set Modem In the modem setup example, the connection from the
Baud Rate PortServer to the modem was set at 2400 baud. Now Betty sets
the modem to 2400 baud.
(The exact command depends upon the brand and model of
modem; refer to your modem documentation when setting up
modem connections.)
Call Service Betty now calls the online information service by telling her
modem to dial the telephone number (Hayes "AT" command
shown; your modems may be different):
ATDT 123-4567
(The example number "123-4567" above would be replaced by
the actual telephone number of the service you are calling.)
Log off Betty exits the online service, then closes the connection to the
modem and logs off her terminal:
close
exit
Also see Modems on page 86 for information on configuring
modems, and using modems and the PortServer with UNIX-
based operating systems.
PortServer Terminal Server Ÿ Page 27