Digi PortServer/8 User Manual page 53

| off
aixon=on
Use auxiliary flow control characters (defined by set keys xona= and set keys
) for output flow control. Default= off
xofa=
| off
altpin=on
Setting Altpin ON switches the function of the DSR and the DCD inputs on the
interface connector, so that DCD is available when using an 8-pin RJ-45 connector
instead of a 10-pin RJ-45 connector. (See RJ Connectors on page 91.)
Default= off
| off
cts=on
Use (or do not use) CTS (Clear To Send) for output flow control. Default= off
| off
dcd=on
Use (or do not use) DCD (Data Carrier Detect) for output flow control. Default= off
| off
dsr=on
Use (or do not use) DSR (Data Set Ready) for output flow control. Default= off
| off
dtr=on
Use (or do not use) DTR (Data Terminal Ready) for input flow control. Default= off
| off
ixoff=on
When ON, use software flow control (typically XON/XOFF) for input data.
Default= on
| off
ixon=on
When ON, use software flow control (typically XON/XOFF) for output data.
Default= on
startport# endport#
range= -
Specify a range of ports to be modified. If not specified, the command will act on the
current port. It is important to specify the port or port range when logged into the
PortServer remotely.
| off
ri=on
When ON, use Ring Indicator (RI) for output flow control. Default= off
| off
rts=on
When ON, use RTS (Request To Send) for input flow control. Default= off
| off
save=on
Save or do not save the changes to EEPROM.
PortServer Terminal Server Ÿ Page 45