Config - Digi PortServer/8 User Manual

config

Syntax:
set config
This sets or displays the network parameters configuration table entries. Options are:
domain gateway
netcx submask
More than one configuration option can be included in a command.
The set config command writes to EEPROM, and informs you of the number of
locations found bad and corrected in EEPROM memory. A non-zero number is
worrisome only when the number of errors begins to approach 64, the maximum
number of entries in the EEPROM patch table. Anyone with more than 40 corrected
errors should contact Digi Technical Support for assistance.
"EP" appears on the front panel display any time a write to EEPROM is in progress.
domain_name
domain=
Specifies the domain name.
ipaddress
gateway=
Sets the IP address of the gateway.
PortServer's_name
myname=
Sets the node name of the PortServer box.
ipaddress
ip=
Sets the PortServer's ip address.
ipaddress
nameserv=
Specifies the name of the domain name server. If an address is not specified, the
host's ip address must be entered using the set host covered on page 46.
tcp_port_number
realport=
This is the RealPort TCP port number, which has a default value of 771 here and in
the RealPort drivers. If this number must be changed because of conflicts, remember
to change it both here and in the RealPort drivers.
subnet mask
submask=
Used to set the network subnet mask. Default=255.255.255.0
Page 42 Ÿ Command Reference
option=value
myname
ether
ip nameserv
boothost bootfile