Transceiver Removal - ZyXEL Communications XGS1930-38 User Manual

Press the transceiver firmly until it clicks into place.
3
The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is functioning
4
properly.
Close the transceiver's latch (latch styles vary).
5
Connect the fiber optic cables to the transceiver.
6
Figure 12 Transceiver Installation Example
Figure 13 Connecting the Fiber Optic Cables

3.1.3.2 Transceiver Removal

Use the following steps to remove an SFP/SFP+ transceiver.
Remove the fiber optic cables from the transceiver.
1
Open the transceiver's latch (latch styles vary).
2
Pull the transceiver out of the slot.
3
Figure 14 Removing the Fiber Optic Cables
Figure 15 Opening the Transceiver's Latch Example
Chapter 3 Hardware Panels
XGS1930 Series User's Guide
30