ZyXEL Communications XGS1930-38 User Manual page 72

Table 20 Status > Neighbor
LABEL
PWR Cycle
Reset to Default
Chapter 7 Status and ZON
DESCRIPTION
Click the Cycle button to turn OFF the power of the neighbor device and turn it back ON
again. A count down button (from 5 to 0) starts.
Note:
• The Switch must support power sourcing (PSE) or the network device is a powered
device (PD).
• If multiple neighbor devices use the same port, the Cycle button is displayed only on
the first device, others will show "-" instead.
Click the Reset button to reset the neighbor device to its factory default settings. A
warning message "Are you sure you want to load factory default?" appears prompting
you to confirm the action. After confirming the action a count down button (from 5 to 0)
starts.
Note:
• The Switch must support power sourcing (PSE) or the network device is a powered
device (PD).
• If multiple neighbor devices use the same port, the Reset button is not available and
will show "-" instead.
• You can only reset Zyxel products.
XGS1930 Series User's Guide
72