Dhcpv6 Client Setup - ZyXEL Communications XGS1930-38 User Manual

Table 43 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup (continued)
LABEL
Interface
Neighbor
Address
MAC
Delete
Cancel

8.10.11 DHCPv6 Client Setup

Use this screen to configure the Switch's DHCP settings when it is acting as a DHCPv6 client. Click the link
next to DHCPv6 Client Setup in the IPv6 Configuration screen to display the screen as shown next.
Figure 78 Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup
The following table describes the labels in this screen.
Table 44 Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup
LABEL
Interface
IA Type
Options
Information
Refresh
Minimum
Chapter 8 Basic Setting
DESCRIPTION
This is the name of the IPv6 interface you created.
This field displays the IPv6 address of the neighboring device which can be reached through the
interface
This field displays the MAC address of the neighboring device which can be reached through the
interface.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the table
heading row to select all entries.
Check the entry(ies) that you want to remove and then click Delete to remove the selected
entry(ies) from the summary table.
Click Cancel to clear the check boxes.
DESCRIPTION
Select the IPv6 interface you want to configure.
Select IA-NA to set the Switch to get a non-temporary IP address from the DHCPv6 server for this
interface.
Optionally, you can also select Rapid-Commit to have the Switch send its DHCPv6 Solicit message
with a Rapid Commit option to obtain information from the DHCPv6 server by a rapid two-
message exchange. The Switch discards any Reply messages that do not include a Rapid
Commit option. The DHCPv6 server should also support the Rapid Commit option to have it work
well.
Select DNS to have the Switch obtain DNS server IPv6 addresses and/or select Domain-List to
have the Switch obtain a list of domain names from the DHCP server.
Specify the time interval (from 600 to 4294967295 seconds) at which the Switch exchanges other
configuration information with a DHCPv6 server again.
XGS1930 Series User's Guide
102